Precise details:
FlySky INr6-HS 2.4GHz 6CH AFHDS 3 RC Receiver Built-in Height Sensor Support Newports Interface PWM/PPM/i.BUS/i.BUS2/S.BUS Output Compatible PL18 Radio for RC Glider Drone
OVERVIEW:
The INr6-HS receiver adopts Flysky's third-generation automatic frequency hopping digital system (AFHDS 3). lt uses a dual-antenna
bidirectional transmission system,with built-in Height Sensor and is uniquely designed to install.It supports 4 Newports function interfaces
(Newports interface can be customized with the input or output signal type:i-BUS2/S.BUS/i-BUS/PPM,etc.).lt adapts all transmitters which support AFHDS 3 protocol.
Specifications: (Manual)
Brand Name: FlySky
Item Name: INr6-HS RC Receiver
Model: INr6-HS
Dimensions: 18*16.8*6.0mm
Weight: 3.0g
PWM Channels: 6
RF: 2.4GHz
2.4G Protocol: AFHDS 3
Range: >1000m (in the air, no interference)
Antenna: Dual Antennas （92.5mm，ipex4 interface）
Input Power: 3.5-9V
Data Output: PWM/PPM/i.BUS/i.BUS2/S.BUS
BVD interface: YES
Height Measurement Range：-500—9000m
Graduation value: 1m
Temperature Range: -10℃ to +60℃
Humidity Limit: 20%-95%
Online Update: Yes
Certification: CE，FCC ID:N4ZINR6HS00
Compatibility:
The receiver is compatible with all transmitters which support AFHDS 3 protocol. (Note: The high-frequency library includes version2.0 and 3.0,the RF version of the transimitter must be same with the RF version of the receiver.)
Features:
Button Binding
LED indicator
Anti-reverse power plug
Support over-the-air update function
Two antennas (length, heat shrink tube)
Built-in height sensor
Application Scenario Glider
low latency mode
Gold-plated pin headers
Support TX slave configuration
Communication distance greater than 1000m
1TX with 2 bidirectional RX function support
4 n.port interfaces, NPA:PWM, NPB:PWM, NPC:PWM, NPD:PWM
Support TX to set the channel number of the first interface output of RX
Binding:
Put the transmitter to enter bind mode.
Press and hold thereceiver BIND button[10] while powering on the receiver,release the BIND button after receiver is powered on or
powering on the receiver first,then press and hold the BIND button 3 seconds,the LED [7] of the receiver will flash rapidly,indicating the
receiver is in bind mode.
The binding process is complete when the LED of the receiver stops flashing and is on continuously.
- If a transmitter that has had its radio frequency (RF Standard) set to“AFHDS3 1 way"(please refer to your transmitter user manual)
enters bind mode,the LED will instead flash slowly.Exit bind mode on the transmitter manually and if the LED of the receiver stops
flashing and is on continuously,the binding process is complete.
Check to make sure the transmitter and receiver functions are working correctly,repeat steps 1 to 3 (binding process) if any problems arise.
Instruction:
After the receiver has completed the binding,the function of its height sensor can be set and used.
Select [BasicMenu]-[Sensor] on the transmitter,and click the height option in the sensor settings;
In this interface,you can set the current,highest level,low alarm value,and high alarm value within the specified range.Please zero the"current" before using it.
Note: The altitude recorded by this altitude sensor is relative altitude,not absolute altitude.
Package Include:
1 x INr6-HS RC Receiver
