All Messages

Q: Is 'data' input on the plug or socket connector?

Asked by Michael on 2021-03-24 03:11:05

JeromeKilby it has JST SM 2.54mm 3 Pin on both sides, the female end is the input or LED 5050SMD WS2812B number one at the start of the chang. the end of the 100 LED RGB Strip has a Male to connect to the next 100 LED RGB Strip. Red wire Is for the 5V DC power then comes he Green wire for data signal input female end and male for output, the white wire is ground.

2021-03-28 10:27:10 Helpful (0)
Submit
Answers (2)

JeromeKilby No it can not, but if you now someone in to electronics it can be done by putting in microphone jake on the back

2021-03-01 04:45:45 Helpful (1)
Submit
Answers (2)

Q: Hello, is it a bluetooth 4.0 device?

Asked by PADEL1967 on 2021-02-02 02:53:34

JeromeKilby I have Google Pixel 3 Phone and use this head unit has no problem connecting to the phone and it uses Bluetooth 5.0, A2DP, LE, aptX HD but i not 100% that its bluetooth 4.0

2021-02-05 04:07:54 Helpful (0)
Submit
Answers (1)

JeromeKilby the size of the Head Unit A Thick Type Size: 178*100*105mm B Thin Type Size: 178*100*50mm

2020-12-03 05:06:51 Helpful (0)
Submit
Answers (3)

Q: Can i install it in mazda 2 2011 model?

Asked by Dore51 on 2020-10-05 02:53:05

JeromeKilby You can by getting a Double 2 Din Fascias Kit to replace the existing sound unit in the Mazda 2 Dashboard

2020-10-14 11:00:41 Helpful (0)
Submit
Answers (2)

JeromeKilby Igot it just for that purpose, found up to 5mm but and its a big but. The black foam board takes 2 pass to cut throw. but i found the white only looks white due to the air bubbles in the foam, so when the laser hits the clear foam it just spreads dispersing the laser light. I have been looking in to replace just the laser with a Laser Wavelength blue violet (405nm) as smaller the wave the less it will diapers when it hits the small air bubbles in the foam. Note Banggood now selling a New ATOMSTACK A5 "20W" Laser Engraving Machine CNC Router, but have not tried it and slightly smaller wavelength.

2020-09-12 07:38:00 Helpful (0)
Submit
Answers (1)

Q: Is the screen anti-glare?

Asked by BG485557416 on 2020-08-30 06:56:28

JeromeKilby No but i have installed so it not able to reflect light

2020-09-04 01:05:05 Helpful (1)
Submit
Answers (3)

Q: Can we use this laser machine to cut depron foam sheets?

Asked by Mefaizsaiyad on 2019-05-07 05:10:21

JeromeKilby I have found that it will cut the black foam but the white will not, as the foam is not really white but clear so light just reflects off it making it look white. So when the laser is trying to cut throw the foam will dispersing the laser light, stopping it focusing its energy from cutting.

2020-08-24 06:07:11 Helpful (0)
Submit
Answers (1)