All Messages

Q: what is the size of the brushless motor ?

Asked by cookingandpie on 2023-05-01 07:16:59

Marco320 It’s a surpass hobby 2838 3800kv

2023-08-14 08:31:15 Helpful (1)
Submit
Answers (3)

Q: What is size and tooth count of main gear? please..

Asked by crykieaus on 2019-12-01 02:21:12

cookingandpie the plastic gear has 40 teeth, the brass pinion gear on motor shaft is 11 teeth

2022-06-08 07:53:29 Helpful (0)
Submit
Answers (2)

cookingandpie great question. i'm quite sure i know the correct answer, as i ran into the same issue. if you get the version of this quad with ELRS built in to the flight controller, then it has firmware v2 of elrs installed - which will NOT bind with any elrs tx module running v1 firmware. however, if you get the version with no built in rx, then it has a full uart to solder in your own receiver to it - which can be any elrs receiver. and this RX can be running firmware v1 of ELRS and will then bind with any elrs tx module running v1 firmware

2022-05-26 08:18:30 Helpful (0)
Submit
Answers (1)

Q: does this fit the xl5 v5 frame

Asked by BG113249191 on 2022-04-30 03:54:01

cookingandpie yes. it will take a 19mm camera - just like the Ratel 2 fpv camera

2022-05-01 01:28:22 Helpful (0)
Submit
Answers (3)

Q: What is the weight of ONE battery?

Asked by BG638381494 on 2022-04-02 08:39:29

cookingandpie i weighed a few and the average weight of one battery is about 13.5g (btw my batteries are about 3 years old - if that makes a difference)

2022-04-03 11:22:59 Helpful (1)
Submit
Answers (2)

Q: looks exactly like a betafpv frame lol

Asked by Rich on 2022-03-02 03:46:54

cookingandpie Obviously a pure coincidence. They share the same thickness of carbon too

2022-03-17 06:57:41 Helpful (0)
Submit
Answers (1)

cookingandpie yes - you will need to solder the wires of the xm RX to the flight controller. the qx7 will already connect to the drone, but the xm will give you better range

2022-03-16 01:44:52 Helpful (1)
Submit
Answers (2)

Q: doess the frsky version support crossfire?

Asked by borsve on 2022-03-03 05:26:23

cookingandpie yes, i think so. you will need to solder the 4 wires of the cf receiver to the flight controller. check out the relevant happymodel frsky spi flight controller board to confirm and see where the wires need to be soldered. its a small board so wont be easy to do.

2022-03-04 08:36:12 Helpful (1)
Submit
Answers (2)