Jonathon
KäXä 1. Insert bind cable into receivers BIND port. 2. Plug esc cable into any other port. Power on, and then receivers and esc LED will start to flash quickly indicating that it has entered bind mode. 3. Put transmitter into bind mode. 4. Binding is successful when receivers and esc LED starts to flash slowly. Power off, and remove bind cable from receiver. 5. Connect servo cables to receiver. Now the whole system should to be work.
2022-05-06 03:07:40 Helpful (0)
We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
djedge77 yes I believe they have been uprated but the description hasn't been updated. I use these with 2s lipo directly connected and all been fine
2023-04-30 05:12:25 Helpful (0)