Matthew Savage
Q: what voltage does the PWM pin accept? is it only 5V or will up to 12v be suitable?
Asked by Matthew Savage on 2019-08-31 03:54:43
Q: Laser only runs when button on top of laser unit is pressed, what do I need to set or reset?
Asked by arphilps on 2019-08-07 07:56:24
Matthew Savage This is normal the button is a safety interlock button.
2019-08-31 03:52:52 Helpful (1)We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
peterbiekens To be on the safe side, stay with TTl (5Volts). The driver board version 2 does have a 3-pin output for laser. Look for the "Choose1" and jumper "Choose"...
2020-04-28 09:28:39 Helpful (0)