Ianlaing1
Q: what is the max power of this module? 250/500..?
Asked by Ianlaing1 on 2021-07-17 02:38:39
Khairi0703 probably 500 mw
2022-05-16 09:55:27 Helpful (0)Q: can this be used with li ion phosphate..?
Asked by Ianlaing1 on 2021-10-01 02:19:49
Msoncen not support
2021-10-08 04:59:46 Helpful (0)Q: well this work with happy model elrs receivers too, or just yours?
Asked by Scotty2Quady on 2021-07-17 09:16:40
Ianlaing1 will work with any expresslrs flashed hardware.
2021-07-18 12:27:25 Helpful (1)Q: Will this work with x8r receiver?
Asked by Colin Doughty on 2021-06-19 04:02:35
Ianlaing1 no
2021-07-17 02:36:10 Helpful (0)Q: is it suitable with Jumper t-lite transmitter?
Asked by KarloBalboa on 2021-04-19 02:37:48
Ianlaing1 if you have a 3d printer then no
2021-07-17 02:34:29 Helpful (0)
Ian The Post for the tx805 json from github will work at rated power the TX805S.. ignor the fact it say 800, its actually providing the full at 1.6w at the 4th power setting...
2021-05-19 09:08:50 Helpful (0)Q: do you have a direct drive version (not Bowden Long range but direct drive for bondtech prusa setup)
Asked by Paul Cole on 2019-03-27 08:40:45
Ian depending on setup with work with say a titan extruder which uses a short PTFE tube ..
2020-11-10 11:28:07 Helpful (0)
Ian After using this heat break for a while longer there are come issues. The Idea is great but the thermal mass of it is small(very light) so heat is not been removed as well as a normal clone e3d style heatsink/heartbreak.. In fact the heatsink is always hot to the touch, not great and you will see the ptfe tube melt a bit in the throat. While is works after a while you will start getting problems. DAM
Q: where can I plug SUMD (graupner sbus) ?
Asked by aircraftfire07 on 2019-03-06 03:49:56
BG451864550 rx3
2020-06-25 02:05:00 Helpful (0)We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
Dave Firmware:betaflight_4.3.0 JHEF411. if you go to the product page and scroll down a little there is Specifications. click on it and More Details you will get everything including the firmware type of your ESCs and a diagram picture
2023-04-18 04:44:45 Helpful (1)