Jonmar
Q: I would like to know how to use the inout and ground side of this board please
Asked by Robert-WI on 2018-03-02 08:32:14
Jonmar To use this unit as a Frequency Counter: One connects the signal (center conductor of a coax cable) to be measured to the (IN) solder pad and the ground (shield of the coax cable) to the (G) solder pad. Maximum input signal should not be greater then 5 volts.
2019-09-23 05:37:38 Helpful (0)Q: how do i use the input and ground side of this kit?
Asked by Robert-WI on 2018-02-28 07:14:17
Jonmar To use this unit as a Frequency Counter: One connects the signal (center conductor of a coax cable) to be measured to the "IN" solder pad and the ground (shield of the coax cable) to the "G" solder pad.
2019-09-23 05:34:09 Helpful (0)We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
