All Messages

Q: will this heater work with an afterburner controller

Asked by BG501141750 on 2023-11-28 09:15:56

BG203725422 I believe that the Bluetooth controller and its mainboard are shown as not compatible with the afterburner controller. If you refer to the afterburner website they list which controllers are compatible and which are not compatible

2023-12-04 02:20:01 Helpful (0)
Submit
Answers (1)

Q: Is this "Carborundum" coated glass?

Asked by RENOxDECEPTION on 2021-04-26 05:29:34

BG203725422 Not sure about the carborundum glass, but I have 4 of these glass beds and use the un-coated side with a bed adhesive, gives very nice smooth finish to the parts. Let the glass bed fully cool down or I even put it my freezer before removing the prints, mostly they just pop off and because the glass provides a tough surface you don’t get damage if z-height offset is a little off.

2022-06-14 01:25:16 Helpful (0)
Submit
Answers (2)

BG203725422 Newer Creality printers come with press fit gears on the extruder stepper motors and are a pain to remove, but you can achieve this and the original motor will work fine. If you want a direct drive unit this should work but mounts will need to be purchased or printed to convert.

2022-06-14 01:21:14 Helpful (0)
Submit
Answers (3)

Q: Will this allow for printing with flexible filament?

Asked by bmack on 2020-09-30 10:58:14

BG203725422 You can print tpu easier with dual gear extruder, but you must adjust z-height adjustment and slow print speed to get any success, don’t go too soft as jams and retraction become serious issues

2022-06-14 01:17:08 Helpful (0)
Submit
Answers (5)

Q: will it fit ender 3 v2?

Asked by simon on 2021-01-16 03:45:22

BG203725422 Yes, you may need new stepper motor as Creality push fit extruder gears and you also need to adjust e-step values

2022-05-30 11:58:44 Helpful (0)
Submit
Answers (2)

Q: Does it fit Ender-3 V2? Thanks

Asked by BG651411359 on 2020-12-26 02:39:57

BG203725422 Yes, but remember you may need a new stepper motor as Creality use push fit gears and adjust your e-step values

2022-05-30 11:57:46 Helpful (0)
Submit
Answers (3)

Q: will it work for ender 7?

Asked by liebendan on 2021-08-29 01:02:56

BG203725422 I don’t know sorry

2022-05-30 11:56:53 Helpful (0)
Submit
Answers (3)