Answers

Q: is this ok for long range? thanks!

Asked by BG252111985 on 2021-01-17 21:39:48

Mikethefly I flew up to 2.8km with a 5 turn helical connected to this goggle. If u want to see the video you'll find it on my utube Channel, Just search for Mike malagoli

Helpful (2)
Submit
Answers (1)

Q: Anybody had issues running rpm-filters on these?

Asked by eskrace on 2020-10-26 19:26:37

Mikethefly I have these on three quads, been using these ESCs over two years, and I only managed to break one in a crash but it was my fault. For the price I think they are well worth it, I'm using DSHOT600 in BF 4.2 all with bidirectional dshot. No proplem with RPM filtering..

Helpful (1)
Submit
Answers (3)

Mikethefly My Aomway Commander internal DVR works with the module connected via AV input. Just try the AV input and see if your DVR records, if it does it will also work with this module.

Helpful (1)
Submit
Answers (1)

Mikethefly The stock antenna should give you up to 200 to 400 meter range depending on the power output of the VTX on your drone. It's ok to begin with but you should definitely invest in say a RHCP cloverleaf antenna. One is sufficient because this goggle does not have true diversity. What this means is that both antennas are connected to the same receiver module. Hope this is useful ciao

Helpful (7)
Submit
Answers (6)

Q: What batteries can I use with this? I am really new to this hobby. Pls help

Asked by julian.samberger on 2020-05-28 10:59:38

Mikethefly If you check the specs it says it can handle 2 to 6s lipos. this means lithium polymer (lipo) battery from to 2 cells to 6 cells. Each cell is rated at 4.2volts multiply by 6 and the maximum voltage this flight controller can handle is approximately 25volts.

Helpful (0)
Submit
Answers (2)

Q: Will these work with the Mirarobot S60?

Asked by BG191164216 on 2020-04-18 16:48:29

Mikethefly The question you need to ask yourself is does the Mirarobot transmit a video signal in 5.8Ghz? If the answer is yes then these gooles will work just fine

Helpful (1)
Submit
Answers (6)

Q: does this support a spektrum reciver?

Asked by bigredscout135 on 2020-02-24 16:19:07

Mikethefly Spektrum receivers run on 3.3volts. So just make sure to use the 3.3v pin to supply power to the Spektrum rx.

Helpful (0)
Submit
Answers (5)

Q: Is this compatible with BlHeli_S ?

Asked by Prasad on 2020-02-16 03:27:35

Mikethefly The FC is compatible with blheli s however if u still haven't purchased the ESCs yet get the Blheli 32 type so as to use the rpm filters for free. If instead u want to use the RPM filters for Blheli s you'll have to pay for the software

Helpful (0)
Submit
Answers (4)