Customer Reviews

4.74 out of 5
See all 199 reviews
Write a Review
  • All Reviews (199)
  • Image (24)
  • Video (0)
  • All Star
    • All Star(199)
    • 5 Star(178)
    • 4 Star(6)
    • 3 Star(6)
    • 2 Star(2)
    • 1 Star(7)
Sort by:
Top Review
  • Top Review
  • Most Helpful
  • Most Recent
Reviews only from your country (New Zealand)
|
Show Original

A part of the review has been auto-translated.

  • 21/09/2016

    I've built and flown all of the Black Flyers: V1, V1.1 and V2. The V1 Is an excellent flyer, but the packaging means that some of the carbon can be broken in the post. The V1.1 and the V2 have improved packaging and a better wing fixing. The V1.1 is very similar to the V1 buthas an increased wing chord giving more wing area. Getting to the V2, it goes together well but, like the V1.1 it has a flat plate wing(s) which require great care in covering to avoid warping. It also means that the lack of wing section combined with the all flying tailplane means that the elevator is very sensitive and trim is critical. Both the V1.1 and V2 have a tendency to 'tuck' and dive into the ground. I feel that this is a design fault and they should have retained the cambered wing. On a value for money basis, you can't beat any of them. Weights with battery: V1 13.5 gm, V1.1 18 gm, V2 18 gm. All covered with tissue, not the supplied film.

    Comments (4)
    Show Original
  • 12/03/2020

    Very good and easy to build indoor flyers. The biggest challenge are the tiny components in particular the area fixing screws. The flight behaviour of the finished flyer is impeccable. With 1S 160mAh, the lightweight brings just 23g to the scale. The engine also has sufficient power and it is possible to loop on the smallest radius. The centre of gravity fits and long flight times are feasible.

    Comments (4)
    Show Original
  • 24/12/2017

    This model went together following the downloaded instructions. As mentioned by others the hardest part was fixing the tiny self tapping screws. Get yourself a very small phillips screwdriver, fit a piece of heat shrink tube on the end to hold the screws while you screw them in. Do all this over a tray with soft cloth inside or you may lose them! I covered my model in crushed silver mylar - to save a little weight and make it look different from the others. It flew dead straight from my hand the first time that I flew it. It flies on half power. It circles tightly and loops easily. Great little model.

    Comments (2)
    Show Original
  • 09/09/2016

    Took about 3 hours to put together. Instructions are lacking of course, I ended up using the electronics from a crashed E-Flite SBach so I'm running its a little faster and heavier than it should be but flies pretty good for 19.99. Use a little super glue and this thing can take a crash for sure.

    Comments
    Show Original
  • 25/05/2020

    I receive my Item but infortunatly there is no Instruction how to build the plane, please let me know how to do thanks for your help regards

    Comments
    Show Original
  • 23/07/2017

    Everything in the kit went together well. Used 3M spray on adhesive on the wings, tailplane and rudder CF assembies, then stretching the mylar covering on a flat board, and then dropping each assembly onto the mylar. Use a sharp craft knife and run around the outside of each assembly. Quite tricky getting the screws into the blocks that hold the wings in place, but got there in the end. Some more information or recommendations regarding ESC and receiver and servos would be good though

    Comments (1)
    Show Original
  • 12/05/2020

    Hard to build, very tiny parts. But when finished, it looks amazing.

    Comments
    Show Original
  • 12/06/2020

    FALSE, A STATUS, THE ARTICLE I BOUGHT I CLEARLY SAID ALL THE PARTS INCLUIDAS HAD ONLY TO MOUNT THEM. GOOD FOLLOW THE ORDER HAS BEEN IN A CASE WITHOUT INSTRUCTIONS NOTHING AND WITHOUT ANY ELECTRICAL COMPONENT FOR YOUR HANDLE SAVING THE PROPULSOR ELECTRIC ENGINE. TOTAL THAT MET ME IN THE SAME ARTICLE THAT I BUY (WHICH I CLEARLY PONNED TO COME WITH EVERYTHING) AND YOU DON'T ALREADY EXIST. I HAVE ANOTHER ANNOUNCEMENT WITH THE SAME ARTICLE PONIENDO THAT DOESN'T COME WITH THESE PARTS TO PUT YOU TO RECEIVE IT IN 10 DAYS AND ALMOST TWO MONTHS IS EXPECTING FOR THIS STATUS. SECOND BUILDING CHINA AND CURIOSELY RETURNS OF CHINESE ARTICLES ARE NOT DONE. TOTAL: DENUNCIA TO THE NATIONAL POLICE WITH ALL THE DATA. (WHICH I OBVIOUSLY HAVE IN PANTALLAZOS) About SINVERGÜENZAS.

    Comments (6)
    Show Original
  • 01/10/2016

    The plane arrived in good shape. I plan on using the parts as spares for the plane I have for indoor flying. Neat design, very delicate, but slow flyer for indoor use.

    Comments
    Show Original
  • 08/08/2020

    When I open the delivery feel very puzzle but when i look at yhe motor and propeller I realized it should be a plane. It's really compact. Hope can completed the assembly. Thank you seller and Banggood.

    Comments
    Show Original
Show:

    Total 0 pages

    Go to page

    Go

    You might be interested in

    recommendation for you
    • US$6.80
    • US$57.99
    • US$84.99
    • US$11.49
    • US$25.29
    • US$169.99
    • US$137.99
    • US$30.59
    • US$24.14
    • US$15.97
    • US$120.00
    • US$89.99
    • US$162.90
    • US$52.99
    • US$119.99
    • US$89.99
    • US$139.99
    • US$57.99