silvio2402
dbelam Yes,just balance the batteries before connecting.
2022-06-15 01:15:06 Helpful (0)Q: does it fit M8*0.5mm lens thread?
Asked by silviobraendle on 2019-10-26 03:14:59
BG145716125 all ok
2022-02-26 04:16:22 Helpful (0)
HamsterHybrid Wennthe module is in "SET" mode, you can't send and receive commands, because the module awaits your settings via Serial. There is no need to constantly have the SET pin grounded, usually you set the module's settings once and that's it.
2021-10-29 05:56:59 Helpful (0)
Henrik NO! The adhesive does NOT conduct. You might get an (unreliable) contact at the edge of the tape, but NOT through the adhesive.
2021-10-25 03:36:24 Helpful (0)
JT_Enliten You may use the Uart pins for the two Arduino boards to connect each other, but you also need to wire their GND pins together.
2021-09-19 02:14:44 Helpful (0)
The seller Here https://www.banggood.com/30_5x30_5mm-MAMBA-F405-MK2-3-6S-Flight-Controller-compatible-DJI-FPV-Air-Unit-for-RC-Drone-FPV-Racing-p-1855166.html?cur_warehouse=CN
2021-06-03 06:08:29 Helpful (0)
We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
efrancois Testedwith a Taranis QX7 only
2022-07-04 12:21:12 Helpful (0)