All Messages

Johan To bad it will not function with Linear Advanced with these drivers, needs the newer tmc2209 or better.

2022-02-03 04:17:42 Helpful (0)
Answers (5)

Johan I believe that the Ender-3 V2 already have this board, the biggest problem with this is that it's not able to handle Linear Advanced.

2022-02-03 04:15:30 Helpful (0)
Answers (6)

Q: The CR-10 has a 310x310mm heatbed, not 300x300mm.

Asked by Johan on 2020-10-03 05:05:00

Tritavus I think you can consider this one

2020-11-04 04:10:14 Helpful (0)
Answers (1)

Johan Doesn't work good, after a lot of work to find out why my printer did diagonal artefacts in my prints, I finally found out that this stepper produces them, have now changed to an exactly the same motor and now it works fine, strange that two identical steppers can be so different.

Johan 02/10/2019
Comments (1)

Johan Asnyou can see, it's an Ender-3 Pro inside so I figure it will fit okay.

2020-01-06 08:27:34 Helpful (3)
Answers (2)