matthijs
matthijs its an ER 11 Collet chuck, the one included, i believe is 5 or 6 mm, not sure. Before the first cut, CHECK YOUR ORIGIN, by that i mean, check where your machine has its zero set. Also check if the machine can travel the extent of your cut file. Keep in mind this machine has NO HOMING SWITCHES and wil absolutely slam into its own frame without having the slightest idea anything is wrong, so supervise it.
2021-11-17 09:44:42 Helpful (0)
Q: is this pnp with ender 3 v1 ?
Asked by pilotgenteng on 2021-01-09 11:13:03
matthijs theender 3 stock control board does not support servo outputs, wich is needed. you can, however, change your control board. But that is quite a lot of trial and error to get everything configured right
2021-03-25 07:50:22 Helpful (1)Q: can be used with lipo 3s battery ?
Asked by Fabian Negrin on 2020-03-11 11:00:57
matthijs youcould, but i recommend using a battery protection board
2021-03-25 07:48:47 Helpful (0)Q: Is it possible to switch the keys with other switches?
Asked by Greendragon on 2018-04-16 09:33:17
matthijs nope
2021-03-25 07:48:07 Helpful (0)We sincerely invite you to subscribe to the Invite Answer email!
If you subscribe, we will invite you via email to answer questions people have about products. By subscribing you]ll also earn the "Helpful Badge"! You can unsubscribe at any time on the privacy settings page.
Help others and be happier!
Thank you for subscribing! You have also earned a badge!
Thank you! Your answer will help ###name### and ###num### other people!
Check awaiting answers to see more people who need help.
Thank you! Your answer will help ###name### and ###num### other people!
Subscribe to "Invite Answer"emails and help others with product questions will earn you "Helpful Badge"!
We invite you to subscribe to our Invite Answer email!
Subscribe and you’ll be invited to answer product’s question by email, which will also earn you a "Helpful Badge"! You can cancel any time on the privacy settings page.
matthijs it has soldering pads for either a 12 v input or a 24 v input
2021-12-21 09:16:13 Helpful (0)