All Messages

Q: Will the screws be included?

Asked by BG105174194 on 2021-05-08 03:50:01

The seller not included

2021-05-10 12:56:06 Helpful (0)
Submit
Answers (1)

BG105174194 The weight is 877g, almost 2 lbs

2021-04-27 06:28:22 Helpful (0)
Submit
Answers (3)

BG105174194 Youneed to cut a trace on the board (close to ADJ pins) to disable adjustable potentiometer.The trace id adjacent to ADJ print - looks like letter H. Then you use set outputs by shunting the set voltage pins (3.5 or 5 or 9 or 12V)

pisqua187 26/11/2019
0
Comments (2)

BG105174194 VO output positive wireGND ground - This is a common connector for input and output ground (negative wire)IN input positive wire EN - enable pin (by default you don't need to connect anything. the default is ENABLED) but grounding this pin will disable the circuit.If yo have let's say 12V and want to get 9V. You cut the trace on the board with razor blade located near ADJ white print - looks like the letter H (to disable adjustable output allowing you to use SET Voltages)You then solder two pins on the board located by 9V white print you will connect positive from your source to IN , negative from your source to GND. Your output will be VO positive wire and the same GND - negative wire.

2021-02-09 01:47:16 Helpful (6)
Submit
Answers (2)

BG105174194 Lucy you. I've got Ripped off. Got less than a third fo them! Received 20 values and 400 pieces - Shorted by 880 pieces. I can officially say I've been BANGed GOOD" this time. Not going to waste my time for customer service as there is a notice that it is too tedious to get the oder right.

Neenad Jaiswal 10/09/2018
0
Comments (1)