It arrived today, assembled and installed. Software: Laser RGBL v7.14. Some comments: _The number of rollers on the feet is low. (My previous 2.5 W device had 2 on the bottom with 3 rollers on top, stable.) The manual has help for setting it up. It is important to check! Interesting that the LightBurn setup failed for the device. (I'll try later) The actual laser power seems to be less than what is indicated in the description. (I'll try this one too.) _Materials cut during test: hard balsa wood: 1.5mm, plastic foam 3mm, inlay sheet hard, decorative rubber - these were ok.

Ma megérkezett, összeszereltem és beüzemeltem. Szoftver: Laser RGBL v7.14. minden rendben van vele. Néhány észrevétel: A görgők száma kevés a talpakon. (Korábbi 2,5 W eszközömön alul 2 felül 3 görgős megoldás, stabil.) A leírásban van a segítség a beállításra. Fontos megnézni! Érdekes, hogy a LightBurn beüzemelése nem sikerült az eszközhöz. (később próbálom) A lézer valós teljesítménye úgy tűnik kisebb a leírásban jelzettnél. (Próbálom még ezt is.) próba során vágott anyagok: kemény balasafa: 1,5 mm, műanyag hab 3mm, intarzia lemez kemény, dekorációs gumi – ezekkel rendben volt. It arrived today, assembled and installed. Software: Laser RGBL v7.14. Some comments: The number of rollers on the feet is low. (My previous 2.5 W device had 2 on the bottom with 3 rollers on top, stable.) The manual has help for setting it up. It is important to check! Interesting that the LightBurn setup failed for the device. (I'll try later) The actual laser power seems to be less than what is indicated in the description. (I'll try this one too.) Materials cut during test: hard balsa wood: 1.5mm, plastic foam 3mm, inlay sheet hard, decorative rubber - these were ok.

It arrived today, assembled and installed. Software: Laser RGBL v7.14. Some comments: _The number of rollers on the feet is low. (My previous 2.5 W device had 2 on the bottom with 3 rollers on top, stable.) The manual has help for setting it up. It is important to check! Interesting that the LightBurn setup failed for the device. (I'll try later) The actual laser power seems to be less than what is indicated in the description. (I'll try this one too.) _Materials cut during test: hard balsa wood: 1.5mm, plastic foam 3mm, inlay sheet hard, decorative rubber - these were ok.

never again!

nikdy vice!

never again!