I have a jumper T16 transmitter so I bought a jumper R1 receiver, makes sense right. I've only gone about half a kilometre in suburbia so far, need to get out of town & test it properly without houses around.

I have a jumper T16 transmitter so I bought a jumper R1 receiver, makes sense right. I've only gone about half a kilometre in suburbia so far, need to get out of town & test it properly without houses around.

I have a jumper T16 transmitter so I bought a jumper R1 receiver, makes sense right. I've only gone about half a kilometre in suburbia so far, need to get out of town & test it properly without houses around.

Maybe because the Jumper split, the package changed But the goods themselves seem to remain the same as they looked at it (^-^) All the quads I own are built on R1 except for off-the-shelf walkera and DJI It's not the smallest lightest, but it supports RSSI and S.Port The IPEX4 antenna used in the 500 series and 600 series is probably small and light, but it is still relatively expensive and there are few products Since R1 is a normal size IPEX, there are many replacement products and antenna type and length can be customized (^-^) So far, we can mount it on quads larger than 90mm size, but sometimes we think the connector is in the way It is nice to have a solder pad specification (^-^)

Jumperが分裂したためか パッケージが変わりました ですが 見た感じでは品物自体は変わって無いようです(^-^) 所有のクワッドは既製品のwalkeraとDJI以外は全てR1でビルドしてます 最小最軽量ではないですが RSSIやS.Portをサポートしてます 500系や600系で使ってるアンテナのIPEX4は小さくて軽量なのでしょうが まだまだ割高で商品が少ないが R1は通常サイズのIPEXなので交換製品が多く アンテナタイプや長さをカスタマイズもできます(^-^) 今のところ90mmサイズより上のクワッドには搭載できてますが たまにコネクターが邪魔だと思う時があります ハンダパット仕様もあると嬉しい(^-^)

Maybe because the Jumper split, the package changed But the goods themselves seem to remain the same as they looked at it (^-^) All the quads I own are built on R1 except for off-the-shelf walkera and DJI It's not the smallest lightest, but it supports RSSI and S.Port The IPEX4 antenna used in the 500 series and 600 series is probably small and light, but it is still relatively expensive and there are few products Since R1 is a normal size IPEX, there are many replacement products and antenna type and length can be customized (^-^) So far, we can mount it on quads larger than 90mm size, but sometimes we think the connector is in the way It is nice to have a solder pad specification (^-^)