Creality 3D® 40*40*10mm 12V High Speed DC Brushless 4010 Cooling Fan For 3D Printer CR-10
A part of the review has been auto-translated.
DC FAN replacement Dont try to make the connection on the connector of the printer cable. First, prepare tools and sleeves. Cut black and red wires at 10/15 cm from the fan. Prepare each wires on the new fan and printer cable. Use sleeves to make the connection and sold and retract with an iron & heater. Warning : DC Fan (wires black & red) and Controled Fan (wires Yellow & blue) are not compatible.
Ok fits perfectly on CR-10
Works great. A direct replacement to the broken fan on my CR10 Mini printer. Yes!
classic
Replaced my original that went bad after 20 hours - works great.
Works fine
Good fan, very quiet. A little pricey, compared to the 24 volt version.
worked perfectly fine :)
Great
This product was easy to install and work perfectly.